1 Topic by Nebulous

  • Nebulous
  • Member
  • Offline
  • Registered: 2008-10-18
  • Posts: 47

Topic: user accounts

I'm experimenting with a NION config. I can write it and deploy it.
If I have the file loaded in NWARE I can connect to the NION where it is installed and control it.
If I don't have the file and try to upload and connect to the processor it asks me to log on. If I use defaultuser, it fails with access denied.
In the program User Accounts all the permissions are granted for the defaultuser.
I can't access the User Management tab in the web interface. It asks me for credentials and refuses access.

What might I be missing to make this nion accessible?

How do I reset the NION so I can gain access to the User Management tab?

Thanks
Pedro

2 Reply by brett.walker

  • brett.walker
  • Administrator
  • Offline
  • Registered: 2017-08-07
  • Posts: 18

Re: user accounts

What version of NWare are you using?  superuser (lower case/no spaces) with no password gives you access to the User Management tab.

Brett

3 Reply by Nebulous

  • Nebulous
  • Member
  • Offline
  • Registered: 2008-10-18
  • Posts: 47

Re: user accounts

I'm using 1.6.3
Thanks for the superuser tip.

4 Reply by Nebulous

  • Nebulous
  • Member
  • Offline
  • Registered: 2008-10-18
  • Posts: 47

Re: user accounts

I think I just answered my own question. When deploying the new file one has to select 'Save Project to Target'.
thanks

5 Reply by brett.walker

  • brett.walker
  • Administrator
  • Offline
  • Registered: 2017-08-07
  • Posts: 18

Re: user accounts

Great!  In later Nware versions, that Save Project to Target box is checked by default.  That's why I was asking the version.  Glad you figured it out!

Brett