Topic: About trPriority parameter
Continue my NION redundancy topic
I think the way to do change CM-1 to backup over is too complicated.
back to NWare CM1 advanced configuration table ,this priority parameter's index is point to the MS Byte of txPriority that means change this parameter only can change the Bundle priority, i tink this is meaningless when the network bandwidth is enough. but if change that index to LS Byte that's a useful parameter for doing redundancy system
do everybody remember the legacy MWare has a pa.ini file , if we want to do the CM1 changeover only need to put the "requestbundulepriority=1" to the [Padpu] section. i think it's same problem.