1 Topic by weidong

  • weidong
  • weidong
  • Member
  • Offline
  • Registered: 2007-12-09
  • Posts: 12

Topic: Nion can not save sub-preset

I got a strange issue about sub-preset.

I can make some new sub-preset and save them, and I could load them very well. Then I turned off Nion's power, after 7 days when I turn on the Nion and want to load sub-preset, I found all presets missing. I tried several times, and I got the same result. What will cause this problem and how to fix it?

By the way, Nion firmware is 1.2.5.

Thanks a lot.

love peace and music
Tibet is one part of China!!!

2 Reply by ivorr

  • ivorr
  • ivorr
  • DSP Geek
  • Offline
  • From: West Des Moines, IA
  • Registered: 2007-08-17
  • Posts: 56

Re: Nion can not save sub-preset

One way to make sure your changes are saved is to save the file to disk then re-deploy. I always do that just before leaving a facility.



NWare/firmware 1.2.5 had a few issues that were cleared up in later versions. You might want to upgrade to NWare/firmware 1.4.2.

If you decide to upgrade, don't forget to update all out of date devices in the file. Click Tools > Update All Out of Date Devices > Yes

The next step is to emulate the file using the Shift key option to force a recompile The keyboard shortcut is Ctrl+Shift+F9

Save the newly compiled file to disk

Deploy the project to the NIONs

Last edited by ivorr (2008-08-01 16:33:58)

The only true wisdom is in knowing you know nothing. -Socrates

ivorr's Website

3 Reply by weidong

  • weidong
  • weidong
  • Member
  • Offline
  • Registered: 2007-12-09
  • Posts: 12

Re: Nion can not save sub-preset

Thanks, Ivor. I will check and try to fix that.

love peace and music
Tibet is one part of China!!!