1 Topic by epjman

  • epjman
  • epjman
  • Member
  • Offline
  • From: Clearwater, FL
  • Registered: 2008-02-15
  • Posts: 21

Topic: z_order

Is there any limitation to the "z_order" for items in a NWare config? I've modified some using inspector to maintain layout order when displayed in Kiosk2Go and now my view file has become unstable and crashing when attempting to deploy. Closing NWare 1.7.2 and stopping pandad seems to correct but I'm trying to push to many systems and is getting annoying.
I've modified the z_order using the following levels -6 through 4, the project prior to crash issue had set -4 through 2.

epjman's Website

2 Reply by Fergy

  • Fergy
  • MM Tech Support
  • Offline
  • From: The Home Office--Meridian
  • Registered: 2007-08-15
  • Posts: 334

Re: z_order

I don't think this is your problem, as I've seen Layers from -1700 to 1600 and have had no problems.

FYI; These were layers created automatically when using "bring to front" and "send to back" feature to controls and graphics that were "grouped" together.

Fergy

Make it intuitive, never leave them guessing.