1 Topic by ChuckH

  • ChuckH
  • Member
  • Offline
  • Registered: 2008-12-21
  • Posts: 2

Topic: Router

I need a 1 in 5 mutually exclusive output router. I do not want to have to use the off states or the mutes.  We are using a third party control and need to call the router and tell it which output to switch to.  The router in Nware when set to a 1 in 5 out acts like an audio DA and the only way to control the outputs is either the mutes or the off state.  I am not that up to speed on the logic aspects of Nware so any help will be appreciated.

2 Reply by Fergy

  • Fergy
  • MM Tech Support
  • Offline
  • From: The Home Office--Meridian
  • Registered: 2007-08-15
  • Posts: 334

Re: Router

UHHH. Chuck, if you don't want to have an off state, or use the mutes, what do you want to do with a 1x5 router?

So what I've attached is a mutually exclusive script that might do what you are asking...But it is using the mutes (because the router countrols uses string values (inclucing zero for off), instead of on/off state).

Is this doing what you want?  If not, tell us more.

Fergy

Post's attachments

Attachment icon Mutually Exclusive Script.npa 32.64 kb, 783 downloads since 2013-05-03 

Make it intuitive, never leave them guessing.

3 Reply by ChuckH

  • ChuckH
  • Member
  • Offline
  • Registered: 2008-12-21
  • Posts: 2

Re: Router

Thanks Fergy, A friend of mine took a look and came up with something very close to what we need.