1 Topic by phils

  • phils
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2007-08-15
  • Posts: 322

Topic: Kiosk 1.4.0/.1 and kiosk_config.xml

Using the separate Kiosk installer, I tried 1.4.1, and it does not appear to look at an appended kiosk_config.xml in the shortcut.

""C:\Program Files\MediaMatrix\NWare Kiosk 1.4.1\" C:\kiosk\config.xml"

1.4.0 is the same.
I've played with different locations for the .xml, and also with the "" marks.

However, using a shortcut as below does work.

"C:\Program Files\MediaMatrix\NWare 1.4.1\NWare.exe" /personality=nware_kiosk C:\kiosk\config.xml

Any thoughts?

"The single biggest problem in communication is the illusion that it has taken place."
                                                                                        - George Bernard Shaw

2 Reply by Fergy

  • Fergy
  • MM Tech Support
  • Offline
  • From: The Home Office--Meridian
  • Registered: 2007-08-15
  • Posts: 334

Re: Kiosk 1.4.0/.1 and kiosk_config.xml

I just installed Kiosk 1.4.1 on a clean machine here, and it works fine.  But if you installed Kiosk on a computer that has a full install of NWare, it will confuse everything.  I suspect this is what has occured.

Let me know, because you are testing the installer out for us.

Thanks

Make it intuitive, never leave them guessing.

3 Reply by phils

  • phils
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2007-08-15
  • Posts: 322

Re: Kiosk 1.4.0/.1 and kiosk_config.xml

Hi Scott, no it wasn't a clean machine, but I'll try that next week.
Thanks.

"The single biggest problem in communication is the illusion that it has taken place."
                                                                                        - George Bernard Shaw