1 Topic by phils

  • phils
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2007-08-15
  • Posts: 322

Topic: Kiosk page link problems

I'm on site, working on a project using nTouch180s (just running Kiosk).

Page jumps/flips/links are being done via Control Properties (Linked to .. Page, Activated).
Some are fired directly from a screen press and these work fine.
Others are fired by various bits of logic (output of PIN decoder, Snapshot Loaded indicator, etc) and even after a bit of playing around (inserting Generic Boolean controls etc) these don't work reliably in Kiosk. They do what's expected in NWare, though.

Any ideas would be appreciated.
Would I be better off going back to the future and using Launchers?

thanks,
Phil

"The single biggest problem in communication is the illusion that it has taken place."
                                                                                        - George Bernard Shaw

2 Reply by phils

  • phils
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2007-08-15
  • Posts: 322

Re: Kiosk page link problems

Thanks Josh for helping.
If anybody is wondering: the amount of control logic I'm running was resulting in the CPU being too busy - hence missing page flips. I'm about to push the control onto nTouch180 (aka nControl lite).

"The single biggest problem in communication is the illusion that it has taken place."
                                                                                        - George Bernard Shaw