Josh's 4-way Signal Probe

Here is another handy little device that I use quite frequently.

It is basically four signal probes, a mixer, and a wave file recorder (for chimp functionality) all rolled into one.

You can use the signal probes to see the difference in relative level between different places in a system. You only need to use one of these devices in your entire project file. You can just copy the controls to each page where you would like to use them. Remember, you can just click in the probe field to recall that probe from wherever it is connected in the project.

You can use the output to feed an output of the system and the RTA device that I shared in another post.

You can just open the ChIMP block to get to the ChIMP controls.