|
|
|
|
In this section |
See also |
UPS Controls |
||
Bank 1-4 |
Switch on/off the AC outlet banks at the rear of the Furman device. When a bank is switched on, the corresponding LED is lit (green). The F1500 has 2 programmable critical load management AC outlet banks (Bank 1 and Bank 2) and two non-critical load AC outlet banks (Bank 3 and Bank 4). Note: You will not be asked to confirm your choice when you switch a bank on or off. Be sure to check that the equipment connected to the bank on the Furman device is ready to be switched on or off before proceeding. |
|
Input/Output |
||
Input VAC |
Mains power input voltage arriving into the UPS. |
|
Output VAC |
Output voltage supplied by the UPS. |
|
Watts |
Power supplied by the UPS. |
|
Amps |
Current supplied by the UPS. |
|
Over Voltage |
Lit when the AC voltage received by the unit exceeds the expected voltage. |
|
Under Voltage |
Lit when the AC voltage received by the unit falls below the expected voltage. |
|
Lost Power |
Lit when power is no longer being received by the unit from the AC power connection. |
|
Test Mode |
Lit when the unit is in test mode. This mode verifies that the UPS inverter can adequately supply the connected load. |
|
Battery Status |
||
Output Load Status |
Percentage of available power currently being drawn from the UPS. |
|
Battery Status |
Percentage charge available in the batteries of the UPS. |
|
Bank 3 Threshold |
The percentage level of charge that must be reached before bank 3 automatically shuts off. The default is 20%. Shutting off this bank will reserve charge for the critical load outlets. |
|
Bank 4 Threshold |
The percentage level of charge that must be reached before bank 4 automatically shuts off. The default is 20%. Shutting off this bank will reserve charge for the critical load outlets. |
|
Buzzer |
Enables/disables the buzzer, which sounds automatically when the AC power supplied to the UPS is interrupted (and the batteries are used to supply power). |
|
Configuration |
||
AVR Mode |
Specifies the automatic voltage regulation mode. |
|
Off |
No automatic voltage regulation. |
|
Standard |
Voltage is adjusted only when larger fluctuations in the level occur. |
|
Sensitive |
Voltage is adjusted when small fluctuations in the level occur. |
|