nTouch

nTouch 60

Purpose

The nTouch 60 device allows you to control and monitor an nTouch 60 installed on the local area network.

The device is created with individual pages that the user can customize. These are the pages that will be visible on the device itself when the project is running.

Notes:

• If you change the number of pages after the device has been created, all the controls you have added to the pages will be deleted. To avoid this problem, you can use a GUI block with the same dimensions as the device, finish the design in the GUI block, then copy the controls over to the device.
• We recommend that you place nTouch 60 devices, Kiosk Layout blocks, Kiosk2Go Layout blocks and Mobile Display blocks on a separate page to the other devices in the project, and do not export the page.

The device also has a Configuration tab with settings for contacting and managing the operation of the device and updating the firmware, and a Controls tab with user interface controls you can copy to the individual pages.

For detailed information on how to install nTouch 60 units and specify the initial configuration settings, refer to the nTouch 60 Hardware Manual.